Ensure the tyre is clean and completely dry before application, spray approx 2-3 sprays of Tyre gloss to our waffle applicator. Work the product into the wall of the tyre ensuring all of the surface is completely covered. This will give you a satin like finish. If you wanted a higher gloss finish on your tyres, leave the first coat to dry approx 10 minutes then apply a few more sprays to the waffle applicator and completely cover the tyre again ensuring you work all the dressing into the markings and letters of the tyre wall surface. Leave to dry and will have a lovely, rich gloss to your tyres that also gives you that durable finish.
Another traditional method of application is applying the product straight to the tyre wall by spraying Tyregloss and completely covering all of the surface. This method my become a little messy as product may start to run down the wheel and tyre, quickly pick up your waffle applicator and wipe the tyre spreading the product around and then you can again control the look of your tyre from a satin to a high gloss finish.
Tyregloss can also be applied by again spraying Tyregloss onto the surface completely covering the tyre. Then you can always use one of our DBS brush to wipe and work the product into the tyre until you get the desired effect. However you must approach this with caution, excess product on the tyre may cause excess product to sit within the markings of the tyre and will cause 'product sling'. Be sure to work the product into the tyre wall to avoid this.